PRODUCT INTRODUCTION
Model: V99R3
Overview
V99R3 is a VDSL2 dual-band wireless Router, provides stable and secure Internet access for users. Chipset runs Dual Core DMIPS with 800Mhz DRAM interface, so that to ensure the high performance of the CPE. It provides up to 100/100/1000 Mbps up/downstream, and supports 802.11b/g/n/ac wireless standards, which is up to 1200Mbps wireless speed, to satisfy the most common use. It also supports VoIP which can bring more convenience to home or office requirement The MIMO technologies and Beam Forming technologies support allows better throughput and better signal coverage.
Hardware Specification
Chipset | Realtek 8685PB+8192ER +8814AR |
Flash | 128MB |
RAM | 128MB DDR3 |
WAN | 1 GE Ethernet ports (10/100/1000Mbps)(OPTIONAL)+ 1DSL Port |
LAN | 4 GE Ethernet ports (10/100/1000Mbps) |
Wireless | 802.11 b/g/n/AC, up to 300Mbps; 11ac, up to 867Mbps;3X3 internal antenna; |
FXS | FXS Port *2 |
USB | USB2.0 Host *2(USB2.0+USB3.0) |
LED | Power DSL WAN LAN4 LAN3 LAN2 LAN1 USB1 USB2 FX1 FX2 2.4G_WIFI 5G_WIFI WPS WAN USB1 USB2 is optional |
Input Power | 12V / 2.0A |
Accessories | RJ45 cable 1.5M; PSU 12V 1.5A EU plug 1.5M wire, 110V ~240V |
Gift box | Brown with “Infinity Wireless” logo and MAC/SN sticker |
Others | One Reset button, MAC/SN sticker and foot cushion on the bottom |
Housing: IW2 | |
MAC:; SN: | |
Dimensions | 222*146*35mm |
Installation | desktop mounting |
Power consumption | <16W |
Environmental | Temperature: - 0 to 50 ℃(Standard Operating) - -20 to 70 ℃(Non-operating) Humidity: - 10% to 90% (Non-condensing, Standard Operating) - 5% to 95% (Non-condensing, Non-operating) |
Firmware Specification
Protocol & Features Supported | |
1 | RFC 2684 IP Bridging & RFC 2684 IP Routing |
2 | RFC 2516, PPPoE (Point over Ethernet) over ATM |
3 | RFC 2364 PPPoA |
4 | Support multiple Routing service (optional) |
5 | QOS based on service and ports |
6 | Routing: RIP v1, RIP v2 |
7 | Support Static Routing |
8 | NAT & PAT (RFC 1631) |
9 | DMZ support |
10 | NAT with Application Layer Gateway |
11 | IP Routing: TCP, UDP, ICMP, ARP |
12 | DHCP Client/Server/Relay |
13 | IP multicasting IGMP v1/v2 |
14 | Pass through/open/redirection and port mapping |
15 | QoS for bandwidth control |
16 | HTTP (web based) for firmware upgrade & configuration |
17 | IP filter |
18 | IGMP Snooping |
19 | IEEE 802.1D Transparent Bridging |
20 | DNS relay |
21 | VDSL2, up to 35b profile |
Firewall Features | |
1 | Source IP address, Destination IP address, Source port addresses, Source MAC address, Destination Port address |
2 | Stateful packet inspection |
3 | Filtering on Application basis |
4 | Filtering on port basis |
Virtual private network support | |
1 | Standard (IPSec, L2TP, PPTP) pass through |
2 | Compatibility with other IPSec VPN gateways |
3 | Supports multiple simultaneous login via FTP/www/Telnet |
Diagnostic | |
1 | support diagnostic function |
Management features & functionalities | |
1 | TFTP/FTP upgrade |
2 | Support TR069 (optional) |
3 | Telnet remote access support |
4 | support Web based configuration |
5 | Support for backup & restore configuration to/from PC |
6 | Support TR-64 for LAN management |
7 | Support DHCP server for IP management |
Quality of Service requirement | |
1 | Port based and IP based QoS |
2 | 802.1Q |
General Specification & Operational requirement | |
1 | System Log |
2 | IPv4/IPv6 Dual Stack |
Applicable for WiFi CPE | |
1 | Wireless Standard and feature - 802.11g/802.11b/802.11n/ac |
2 | 64/128 bit WEP support |
3 | MAC association control |
4 | Support Multiple SSIDs |
5 | Support for WEP, WPA, WPA2, WPA2 Enterprise(802.1X) |
6 | “0 Configuration” function with i01 smart repeater, to simply expand WiFi coverage with high performance. |
7 | Files Storage System for WAN and LAN ( available on phase 2) |
Scan the qrcode to reading this article on your phone